Maximum Speed Potentiometer Disassembly/Assembly (For Adfinity™ X20R, 20D, X20D, X20C, X24D) - Advance acoustic Adfinity 17ST Service Manual

MAXIMUM SPEED POTENTIOMETER DISASSEMBLY/ASSEMBLY (Adfinity™ X20R, 20D, X20D, X20C,
X24D)
Disassembly
1. Disconnect the battery connector (12).
2. Operating inside the hole (A), loosen the threaded dowel and remove the maximum speed adjuster knob (B).
3. Unscrew the potentiometer mounting nut (C).
4. Remove the screws (D) and move the cover (E).
5. Cut the fastening clamp (F) and disconnect the potentiometer connector (G).
6. Open the clamp (H).
7. Remove the potentiometer with the relevant wiring harness (I).Check and replacement
Assembly
8. Assemble the components in the reverse order of disassembly, and note the following:
• Fasten the knob (B) with the potentiometer shaft (L) completely turned to the left and the hole (A) in the lower centre part of
the panel as shown in the figure.
9. Test the drive system and the maximum speed change.
D
B
C
Adfinity™ 17ST / 20ST / X20R / 20D / X20D / X20C / X24D
E
D
B
A
L
SERVICE MANUAL
G
F
I
ENGLISH
DRIVE SYSTEM
H
69
9096982000
E
S310560A