Mitsubishi Electric FR-D720-0.1K Instruction Manual page 73

Parameter list
Func-
Parameter Name
tion
Pr.CL Parameter clear
ALLC All parameter clear
Er.CL Faults history clear
Pr.CH Initial value change list
∗1
Differ according to capacities.
6%: 0.75K or lower
4%: 1.5K to 3.7K
3%: 5.5K, 7.5K
2%: 11K, 15K
∗2 Differ according to capacities.
5s: 3.7K or lower
10s: 5.5K, 7.5K
15s: 11K, 15K
∗3
Differ according to capacities.
6%: 0.1K, 0.2K
4%: 0.4K to 7.5K
2%: 11K, 15K
∗4 Write is disabled in the communication mode (Network operation mode) from the PU connector.
∗5 The initial value differs according to the voltage class. (100V class, 200V class / 400V class)
∗6
Set this parameter when calibrating the operation panel built-in potentiometer for the FR-E500 series operation panel (PA02) connected with cable.
∗7
The parameter number in parentheses is the one for use with the operation panel (PA02) for the FR-E500 series or parameter unit (FR-PU04/FR-PU07).
∗8
These parameters are communication parameters that are not cleared when parameter clear (all clear) is executed from RS-485 communication. (Refer to
page 179 for RS-485 communication)
∗9 Available only for the three-phase power input model.
70
Minimum Refer
Initial
Setting Range Setting to
Value
Increments Page
0, 1 1 0 248
0, 1 1 0 248
0, 1 1 0 250
— — — 249
Customer
Parameter Remarks
Setting
Pr.CL
ALLC
Er.CL
Pr.CH
Control Mode-based
Instruction Code
Correspondence Table
Read Write Extended Copy
V/F V/F V/F GP MFVC GP MFVC GP MFVC
— FC — — —
— FC — — —
— F4 — — —
— — — — —
Parameter list
Parameter
Clear All clear
— — —
— — —
— — —
— — —
4