Handling And Installation Precautions - Sega MINI DELUXE THE HOUSE OF THE DEAD 4 Service Manual

3.

HANDLING AND INSTALLATION PRECAUTIONS

•
Installation and commissioning should only be carried out by a QUALIFIED
SERVICE PERONNEL.
When installing or inspecting the machine, be very careful of the following points and pay attention to
ensure that the player can enjoy the game safely.
The game must NOT be installed under the following conditions:
•
Outside, the game is designed for indoor use only.
•
In areas directly exposed to sunlight, high humidity, dust, excessive heat or extreme cold.
•
In locations that would present an obstacle in the case of an emergency i.e. near fire equipment or
emergency exits.
•
On unstable surfaces or surfaces subject to vibration.
•
Where liquids, other than routine cleaning, may come into contact with the game.
Important:
•
This machine should only be installed by Qualified Service Personnel.
•
Ensure that the line supply voltage matches that of the transformer input tapping. For more information
see the section in this manual dealing with changing the transformer voltage.
•
Please note that the input voltage of the machine has been set during manufacture to 230V AC
•
Be sure to switch the supply power OFF and remove the mains supply plug from the machine before
any work is carried out on the machine.
•
Do not attempt to repair the PCB's (Printed Circuit Boards) yourself. This will void the warranty. The
PCB's contain static sensitive devices that could be damaged.
•
Always return a faulty part to your distributor with adequate packaging and protection.
•
When removing the plug from the mains always grasp the plug not the cable.
•
Do not use a fuse that does not meet the specified rating.
•
Make sure all connections are secure before applying power.
•
Ensure that the mains lead is not damaged. If the main lead is damaged in any way
there could be a danger of electrical shock or fire hazard.
•
Ensure that the power supply is fitted with a circuit protection device. Using power
supply without circuit protection is a fire hazard.
5