Inspections Immediately After Transporting The Product To The Location - Sega MINI DELUXE THE HOUSE OF THE DEAD 4 Service Manual

To ensure maximum safety for both customers and operators, stickers and printed instructions describing
potentially hazardous situations are applied to places where accidents could occur. Ensure that where the
product is operated has sufficient lighting to allow any warnings to be read. If any sticker or printed warning
is removed or defaced, do not operate the machine, until it has been replaced by an identical item.
When handling the monitor, be very careful. (Applies only to product with monitor)
Some of the monitor (TV) parts are subject to high tension voltage. Even after turning off the power some
components are still occasionally subject to high tension voltage. Monitor repair and replacement should be
performed by qualified service engineers only.
In cases where commercially available monitors and printers are used only the contents relating to this
product are stated in this manual. Some commercially available equipment has functions and reactions not
stated in this manual. Read this manual in conjunction with the specific manual of such equipment.
Descriptions contained herein may be subject to change without prior notification.
The contents described herein are fully prepared with due care. However, should any question arise or
errors be found please contact SEGA.
1.1. INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT
TO THE LOCATION
Normally, at the time of shipment, SEGA products are in a state to allowing usage immediately after
transporting to the location. Nevertheless, an irregular situation may arise during transportation preventing
this. Before turning on the power, check the following points to ensure that the product has been
transported safely.
•
Are then any dented parts or defects (cuts, etc.) on the external surfaces of the product.?
•
Are castors and leg adjusters present and undamaged?
•
Do the power supply voltage and frequency requirements meet with the local supply?
•
Are all wiring connectors correctly and securely connected? Unless connected in the correct direction,
connector connections cannot be made successfully. Do not insert connectors forcibly.
•
Are all IC's of each IC BD firmly inserted?
•
Does the power cord have any cuts or dents?
•
Do fuses meet the specified rating?
•
Are such units such as monitors, control equipment, IC BD, etc. firmly secured?
•
Are all earth wires connected?
•
Are all accessories available?
•
Can all doors and lids be opened with the accessory keys and/or tools?
2