Coin Mech Installation And Credit Board Set Up; Introduction - Sega MINI DELUXE THE HOUSE OF THE DEAD 4 Service Manual

10.2. COIN MECH INSTALLATION AND CREDIT BOARD SET UP

10.2.1.INTRODUCTION

Game credits between the Coin Mechanism and the game board for this machine are controlled by a VTS
board. This electronic circuit allows the price of play to be set for a range of different countries. These
functions are set on Dual In Line (DIL) PCB mounted switches.
DIL-2 is used to set the currency (or coin ratio) and DIL-1 the price of play. Refer to the Tables on the
following pages for the correct settings for your environment.
The Klingon2 board pictured below is mounted on the VTS Bracket within the Coin Chute Tower.
The Klingon2 board is connected to the coin validator and lamps via a dedicated wiring harness depending
upon the coin validator used:
Wiring Harness Validator
LM1006 Coin Controls
LM1007 Mars
LM1008 Mechanical
N/A NRI
Notes
1. If NRI mechanisms are to be used, these should be ordered with the highest denomination coin on coin
path #1 and the lowest denomination on coin path #4. The VTS board should be then be set up for
either the UK or EURO settings. A minimum connecting lead length of 600mm is required.
2. Mechanical coin mechanisms may be connected in parallel allowing two identical mechanisms to be
fitted.
Illustration showing COIN TOWER, VTS PCB, COIN VALIDATOR and ASSOCIATED HARNESSES
(15 way connector)
(13 way connector)
See note 2
See note 1
67