Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
Menu item
[Total Fuel Capacity]
[Manual Fuel Manage-
ment]
[Initial Setup] menu - [IF-NMEAFI SETUP]
Menu item
[Select IF]
[Category]
[Resistance Full]
[Resistance Mid]
[Resistance Empty]
[Capacity]
[Self test]
[Set Hardware to
Factory Default]
[Initial Setup] menu - [DATA ACQUISITION]
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
Note: If the TTM sentence
is received at the same
time as another sentence,
the constraints to commu-
nication bandwidth may
cause a decrease in the
number of TTM targets.
[NMEA2000 PGN Output]
[Sky View]
[Initial Setup] menu - [INTERNAL GPS SETUP]
Menu Item
[WAAS Mode]
3-20
Manual Fuel Management Setup
Description
Enter the total fuel capacity of your
tank(s).
Set to [ON] for manual fuel manage-
ment. See the Operator's Manual.
Description
Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
The setting is made after restarting the IF-NMEAFI.
Select the use (category) for this sensor.
The resistance, in Ohms, when the tank is full. 0 (ohm) to 500 (Ohm)
The resistance, in Ohms, when the tank is half
full.
The resistance, in Ohms, when the tank is
empty.
The capacity of the tank.
Test results are displayed.
Resets the converter selected at
[Select IF] to factory default.
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
[Port Configuration] - [Baud Rate]: Select
the output baud rate.
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA0183 version for
output.
[Sentences]: Select the sentences to out-
put.
Select [ON] for the PGN's (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your GPS receiver appear.
Description
Set to [OFF] when using external GPS.
Options (setting range)
0 to 9,999(L).
[OFF], [ON].
Options (setting range)
[Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
0 (ohm) to 500 (Ohm)
0 (ohm) to 500 (Ohm)
0 (G) to 2650 (G)
[OK], [Cancel]
Options (setting range)
[ON], [OFF]
[4,800], [9,600], [38,400]
[1.5], [2.0], [3.0]
[ON], [OFF]
Options (setting range)
[ON], [OFF]
Advertisement
Table of Contents
