Suzuki SMD12 Installation Manual page 15

1.4.2 How to mount the SMD16
Use the optional kit Bracket (contents shown below), for mounting the SMD16.
Type
OP19-14
1. Fix the hanger by using self-tapping screws (520 SUS304, supplied). The screw
locations are indicated in the figure below.
2. Place the SMD16 face-down on a soft, clean surface, then fit the washers and
knob bolts as shown in the figure below, leaving a gap of approximately 30 mm.
The washers have a leading edge which must face the unit.
Washer
Knob
3. Set the SMD16 unit to the hanger and tighten the knob bolts.
Knob bolt
Code
Knob bolt  2 (Code No.: 100-346-502-10), Washer  2
001-337-420
(Code No.: 100-076-101-10), Self-tapping screws (SUS304
520)  4 (Code No.: 000-162-608-10), Hanger  1 (Code:
No.: 001-360-970).
Hanger
Contents
Washer
Washer leading edge
1. MOUNTING
Knob
Knob bolt
1-7