2.3.5
How to connect operator fitness to a BR-500
Note: Operator fitness does not require adjustments in the menu.
1. Referring to the figure below, place heat shrink tubes on the wires, then solder the
connection point. (Refer to the BR-500 installer's manual for the appropriate wires
at the BR-500.)
2. Move the heat shrink tubes to the soldered connection, then apply heat to the
tubes.
3. Secure any unused wires, referring to "How to isolate and secure unused
wires" on page 2-3.
Secure unused
wires with tape here
Multi cable
Purple
Brown
Solder the connection point, then set
the heat shrink tube to the cores.
2. WIRING
BR-500
BR-500
2-5