Table of Contents
Advertisement
1. MOUNTING
2) Put the transducer into water-filled plastic bag.
Press the transducer against the chosen site.
3) Tap
4) After the startup procedure completes (approx.
90 seconds), the last used display appears.
Tap the [Home] icon (
show the home screen and display mode
settings. See section 3.6 for how to use the
menu.
5) Drag the menu to show [Sounder] in the menu, then tap [Sounder].
6) Drag the [Sounder] menu to show the [SOUNDER INITIAL SETUP] menu.
7) Tap [Fish Finder Source].
8) Confirm the available fish finder from the list of available sounders, then tap
the appropriate fish finder. For the purpose of this example, the default setting
[SMD] (internal sounder) is selected as the source.
9) Tap the [<] icon to return to the [Sounder] menu
10) Drag the [Sounder] menu to show the [SOUNDER INITIAL SETUP] menu.
11) Tap [Transducer Setup].
12) Tap [Transducer Setup Type].
13) Tap [Model], then tap the [<] icon to return to [Transducer Setup] menu.
14) Tap [Model Number], drag the menu to show your transducer model, then tap
the transducer model number.
15) Tap the [<] icon twice to return to the [Sounder] menu, then drag the [Sounder]
to show the [SOUNDER INITIAL SETUP] menu.
16) At the [Transmission Power] menu item, set the transmission power to a level
of [2].
17) Drag the menu to show [Sounder Transmit], then tap [Sounder Transmit].
Check if the bottom echo appears on the right side of the screen, in the display
area.
If no bottom echo appears, repeat the procedure unit a suitable location is
found.
3. Remove the transducer from the plastic bag and wipe the face of transducer with
a cloth to remove water and any foreign material. Lightly roughen the face with
#100 sandpaper. Also, use the sandpaper to roughen the inside of the hull where
the transducer is to be mounted.
4. Wipe off any sandpaper dust from the face of the transducer.
1-12
(power switch) to turn the power on.
) to
Hull plate
Plastic bag
Water
Advertisement
Table of Contents
