Suzuki SMD12 Installation Manual page 14

1. MOUNTING
1.4 Desktop Mounting (option)
Follow the appropriate procedure below to mount the Multi-Function Display.
Note: Remove the flush mounting sponges attached to the back of the Multi-Function
Display. Take care that there is no sponge left on the back of the Multi-Function Dis-
play.
1.4.1 How to mount the SMD12
Use the optional kit Bracket (contents shown below), for mounting the SMD12.
Type
OP19-13
1. Fix the hanger by using self-tapping screws (520
SUS304, supplied). The screw locations are indicated
in the figure to the right.
2. Place the SMD12 face-down on a soft, clean
surface, then screw the knob bolts into the
SMD12, leaving a gap of approximately 30
mm.
3. Set the SMD12 unit to the hanger and tighten
the knob bolts.
Note: When setting the SMD12 into the hang-
er, the concave section of the unit and the con-
vex section of the hanger must be aligned.
1-6
Code
Knob bolt  2 (Code No.: 100-365-900-10), Self-tapping
001-337-410
screws (SUS304 520)  4 (Code No.: 000-162-608-10),
Hanger  1 (Code No.: 100-397-080-10).
Contents
Approx. 30 mm gap
Knob bolts
Unit concave Hanger convex
Hanger