Flush Mounting - Suzuki SMD12 Installation Manual

1. MOUNTING
1.2

Flush Mounting

There are two methods of flush mount installation. One method uses pilot holes to se-
cure the panel at the installation location (Method B), the other method does not use
pilot holes (Method A). The merits and demerits of each method is listed in the table
below.
Merits
Demerits
Referring to the figure below, select a flat mounting location. Read the installation in-
structions before starting. Pay particular attention to the notes; failure to follow these
instructions may cause damage to the unit.
Note: Ensure the mounting location is flat, with no indents or protrusions, to allow a
secure fit.
Flat
1.2.1 Method A: Pilot holes cannot be opened.
1. Prepare a cutout in the mounting location using the template (supplied) for the
Multi-Function Display.
2. Fasten the wing bolts and the wing nuts of the flush mount fixture so that the pro-
tector for screw moves to the flush mount fixture.
Flush mount fixture
Note: Slowly fasten the four wing bolts evenly with your hand. Do not use a tool
to fasten the wing bolts. A tool can be used to fasten the wing nuts; use caution
so as not to damage the wings or thread.
1-2
Method A
No pilot holes are required.
Fine adjustment is available.
Longer process than Method A. Pilot holes are required.
Curved
Wing nut
Method B
Shorter process than Method A.
Fine adjustment is not available.
Bumpy
Wing bolt
Flush mount fixture
Protector for screw
Move to the fixture