Suzuki SMD12 Installation Manual page 13

1. Prepare a cutout in the mounting location using the template (supplied) for the
Multi-Function Display.
Hex bolt
Frontmount panel
2. Place the Multi-Function Display unit face-down on a a soft, clean surface.
3. Set the F Mount Panel to the Multi-Function Display unit, then using the hex bolts
attached to Multi-Function Display, fix the F Mount Panel to the unit.
4. Set the unit and F Mount Panel into the cutout as shown in the figure to the right,
then use the supplied self-tapping screws (SUS304  4 pcs.), fix the F Mount
Panel to the console.
Note: Where the mounting location may be exposed to water (spray or splash),
apply a bead of marine sealant around the rear of the F Mount Panel, for
waterproofing, before setting the F Mount Panel and unit into the cutout. Wipe the
area clean to remove any marine sealant residue and allow time for the marine
sealant to dry.
Multi-Function Display Multi-Function Display
Self-tapping
SUS304 screws
1. MOUNTING
Hex bolt
1-5