Suzuki SMD12 Installation Manual page 11

3. Connect all cables at the back of the Multi-Function Display (See chapter 2).
4. Set the Multi-Function Display to the cutout.
5. Set Multi-Function Display to the cutout made with step 1.
1. Set Multi-Function Display to the cutout. 2. Fasten Multi-Function Display with flush mount fixture.
6. Fasten each wing bolt so that the protector for screw touches the mounting panel.
7. Fasten the wing nuts tightly.
SMD SMD
unit unit
Note: Use of excessive torque when fastening the wing bolts can cause the flush
mount fixture to tilt or warp. Check that the flush mount fixtures and wing bolts are
not tilted or warped, referring to the following examples.
Flush mount fixture is fixed at right angle.
Wing bolt
Wing nut
Flush mounting fixture
Protector for screw
Mounting panel
Flush mount fixture is warped,
wing bolts are tilted.
1. MOUNTING
1-3