Starting The Projector With A Password - Epson PowerLite 825 User Manual

9. To enable network setting protection, select
and press . Select
Enter
When this feature is on, none of the network settings on the
menu can be changed.

Starting the Projector with a Password

When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the button on the remote control and use the
Num
numeric keypad to enter the four digit password.
The password screen closes, the numeric keypad is automatically
deactivated, and projection begins.
If the password is not correct, you see a message prompting you to
re-enter the password. If you enter an incorrect password three times
in succession, you see the message
locked. Request code xxxxx
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector's power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
If you enter an incorrect password 30 times in succession, the
projector remains locked and you must contact Epson to have the
projector serviced.
Network Protect
and press .
On Enter
The projector's operation will be
and the projector switches to standby
Fine-Tuning the Projector
97