Cleaning The Air Filter And Vent - Epson PowerLite 825 User Manual

Cleaning the Air Filter and Vent

Your projector includes an air filter to ensure the best performance. If
dust collects on the air filter or vent, clean them as described below.
Dust clogs prevent proper ventilation and can cause overheating and
damage the projector.
If you see the following message, clean the air filter immediately.
The projector is overheating. Make sure nothing is blocking the
air vent, and clean or replace the air filter.
1. Turn off the projector. Wait for the Ppower light to stop
flashing, then unplug the power cord.
2. To clean the intake vent and filter, use a small vacuum cleaner
designed for computers and other office equipment. If you don't
have one, gently clean the vent with a soft brush (such as an
artist's paintbrush).
You can remove the air filter to clean both sides. For instructions,
see page 110.
The exhaust
vent is on the
other side of
the projector
3. If the dirt is difficult to remove or the filter is damaged, or if the
message appears again after cleaning, replace the filter as described
on page 110. Contact your dealer or call Epson at
800-GO-EPSON (800-463-7766) to purchase a new filter.
note
To order replacement air
filters, request part number
V13H134A22. See page 13
for ordering information.
Maintaining the Projector
105