Table of Contents
Advertisement
Starting the Projector With a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the
button and use the numeric keypad to enter the
Num
four digit password.
The password screen closes and projection begins.
If projection does not begin, check the following:
If the password is not correct, you see a message prompting you to
■
re-enter the password. If you enter an incorrect password three
times in succession, you see an error code with the message
projector's operation will be locked
to standby mode. Write down the error code, then disconnect the
projector's power cord from the electrical outlet, reconnect it, and
turn the projector back on. Try entering the correct password
again.
■
If you have forgotten the password, contact Epson with the
request code number that appears in the Password screen for
assistance. See "Where To Get Help" on page 105.
If you enter an incorrect password 30 times in succession, the
■
projector remains locked and you must contact Epson to arrange
for service.
The
and the projector switches
note
If you leave the projector
plugged in, the Password
screen will not appear. It
appears only if you unplug
and reconnect the power
cord.
Hold down
Fine-Tuning the Projector
79
Advertisement
Table of Contents
