Using A Browser To Control The Projector - Epson PowerLite 825 User Manual

Using the Projector on a Network
86
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
5. For
Priority Gateway
6. If your network environment uses an AMX controller, select
to allow the projector to be detected by AMX Device Discovery.

Using a Browser to Control the Projector

You can use a standard web browser to monitor and control the
projector through the network.
1. Make sure that the projector is set up for your network, as
described on page 54. (Standby Mode in the Extended menu
should be set to
Communication On
standby mode.) When using a browser to access the projector, you
cannot connect through a proxy server.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you're not sure what the address of the projector is, turn the
projector on and select
Info.-Wireless LAN
address of the projector.
3. Click , or, if you set a Web control password in the projector's
OK
Network menu, enter your user name and password, then click
.
OK
4. Select one of the menu options listed on the screen, then change
any of the settings as needed. These settings correspond to those
found in the projector's menu system.
You cannot change the following settings using a web browser:
■ Pointer Shape, Test Pattern,
Settings menu
,
■ User's Logo
in the Extended menu
Language
and
■ Reset All
, select or
Wired Wireless
to monitor the projector in
Net. Info.-Wired LAN
from the Network menu to display the IP
or
User Button
,
High Altitude Mode
in the Reset menu
Reset Lamp Hours
.
ON
or
Net.
in the
and
Lens Cover Timer