Vehicle Presets; Heater; Windshield Wipers & Radio & Headlights; Arming And Disarming The Starter Kill (If Installed) - Directed Smart Start ASRF-1510 User Manual

Vehicle Presets

Heater

When leaving the vehicle it is recommended to preset the accessory controls in
preparation for the next remote start. Settings for the blower motor (fan), front
and rear, should not be left on HIGH. It is recommended to leave the settings on
LOW or MEDIUM instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight
circuits to become energized while running under remote start. When leaving the
vehicle you must ensure that the windshield wiper and headlight switches are
OFF. Leaving the headlight switch ON on certain types of vehicles could cause
them to remain ON even after remote starter shut down, resulting in a dead
battery.

Arming and disarming the starter kill (if installed)

This added security feature will prevent the vehicle from starting with the Ignition
key when the starter kill is armed. If the system was installed with the starter kill
option, the vehicle will not be able to start with the key unless the system has
been unlocked first or put into Valet Mode (page 13).
Note: If the Starter Kill is installed, the vehicle will benefit from a protection
against starter motor damage that could occur after remote-starting the engine
should the user, by force of habit, turn the ignition key to the CRANK position.
The Starter Kill (if installed) can be configured by the installer either to Passive
Mode (so as to arm automatically) or Active Mode (so as to require the user's
intervention for arming). By default, the Remote Car Starter is configured to
Passive Mode.
User Guide P.7