Manual Transmission Starting; Security System Features; Last Door Arming; Automatic Rearming - Excalibur AL-1775-3DB Operation Manual

MANUAL TRANSMISSION STARTING

Remote starting with a manual transmission requires that you ensure the gear selector
is in NEUTRAL There are 2 available methods
METHOD #1 - 3D MOTION SENSOR:
This system is equipped with a 3D motion sensor built into the antenna Whenever remote
start is activated, this sensor is monitored for vehicle movement If the vehicle moves just
a few inches when the engine is cranking, it will instantly turn the engine off This safety
feature allows you to enjoy remote start without performing reservation mode as described
below
METHOD #2 - RESERVATION MODE:
For extra safety, installer feature #11 can be turned on which requires you to perform a
setup procedure that ensures the transmission was left in neutral when you park your
vehicle This must be performed each time you leave your vehicle to use remote start
later To do so, follow these steps:
1) With the engine running via the ignition switch, hold the brake pedal, apply the parking
brake, then release the brake pedal
2) Use the transmitter as if you were activating remote start (default: press START twice)
The status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle
4) Press LOCK on the transmitter The engine will shut down (unless turbo timer is on)
and the status light will flash every 2 seconds (ready to be remote started).
NOTE: Manual transmission starting is canceled if you enter the vehicle after
performing the setup procedure.

LAST DOOR ARMING

This system can be configured to arm automatically when all the vehicle's doors
are closed (see user feature #9) When this feature is utilized, the siren/horn will chirp
once when all of the doors are closed At that point, it will start a 30 second countdown
(indicated by a fast flashing status light). After 30 seconds, the system will arm (and lock
the doors if configured to do so). During the 30 second arming delay, if a point of entry is
opened, the countdown will pause until all entry points are closed again Turning ON the
ignition key will cancel the last door arming sequence until the key is turned off and the
doors are all closed once again

AUTOMATIC REARMING

This automatically rearms the alarm if the system is disarmed from the remote
(see user feature #10) When disarmed by remote, the system will start a 90 second
countdown (fast flashing status light) to arm the system. This is useful if the controller
accidentally disarms the system when it's kept in a purse or pocket where other items
could potentially press the buttons ENHANCED AUTO REARM allows you to cancel
the countdown by pressing UNLOCK a second time within 5 seconds of the first press to
disarm the alarm

PRE-WARN DETECTION

This system's impact sensor is designed, in addition to detecting a full impact, will warn
away potential violators when it detects a light impact to the vehicle The
system will respond by chirping the siren/horn 3 times and locking the doors
Other Remote Start Features (cont'd)

Security System Features

9