Table of Contents
Advertisement
LIMITED LIFETIME WARRANTY
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company),
are warranted to be free from defects in materials and workmanship under normal use. If a
product sold by the Company proves to be defective, the Company will repair or replace it free
of charge within the first year and thereafter all parts to be repaired will be free with only a
nominal charge for Omega Research and Development, Inc.'s labor and return shipping, to the
original owner during the lifetime of the car in which it was originally installed.
All products for warranty repair must be sent postage prepaid to Omega Research &
Development, Inc., P.O. Box 508, Douglasville, Georgia 30133, with bill of sale or other dated proof
of purchase. This warranty is nontransferable and does not apply to any product damaged by
accident, physical or electrical misuse or abuse, improper installation, alteration, any use contrary
to its intended function, unauthorized service, fire, flood, lightning, or other acts of God.
This warranty limits the Company's liability to the repair or replacement of the product. The
Company shall not be responsible for removal and/or reinstallation charges, damage to or theft of the
vehicle or its contents, or any incidental or consequential damages caused by any failure or alleged
failure of the product to function properly. Under No Circumstances Should This Warranty, Or The
Product Covered By It, Be Construed As A Guarantee Or Insurance Policy Against Loss. The
Company neither assumes nor authorizes any person or organization to make any Warranties or
assume any liability in connection with the sale, installation, or use of this product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference and, (2) This device must accept any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio TV interference caused by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment.
One or more of these patents may apply to this product:
#5,612,669 #5,654,688 #5,663,704 #5,729,191 #5,818,329 #5,612,578 #5,739,747 #382,558 #385,878 #5,750,942
#5,739,748 #5,719,551 #406,107 #701,285 #5,973,592 #5,982,277 #5,986,571 #6,011,460 #6,037,859 #6,049,268
#6,130,605 #6,130,606 #6,140,938 #6,140,939 #6,150,926 #6,144,315 #6,184,780 #6,188,326 #6,243,004 #6,249,216
#6,275,147 #6,297,731 #6,320,514 #6,320,498 #6,346,876 #6,346,877 #6,366,198 #6,392,534 #6,429,768 #6,433,677
#6,480,095 #6,480,117 #6,480,098
Foreign Patent #199700312 #EP0817734B1 #98906445.6 #2,320,248 #701,285
OPERATING & INSTALLATION
08/07 MA_EXRS11
INSTRUCTIONS
RS-11
REMOTE STARTER
FOR AUTOMATIC TRANSMISSION VEHICLES ONLY
COPYRIGHT: OMEGA RESEARCH & DEVELOPMENT 2007
Advertisement
Table of Contents
Related Manuals for Excalibur Excalibur RS-11
Summary of Contents for Excalibur Excalibur RS-11
- Page 1 LIMITED LIFETIME WARRANTY Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company), are warranted to be free from defects in materials and workmanship under normal use. If a product sold by the Company proves to be defective, the Company will repair or replace it free of charge within the first year and thereafter all parts to be repaired will be free with only a nominal charge for Omega Research and Development, Inc.'s labor and return shipping, to the original owner during the lifetime of the car in which it was originally installed.
-
Page 2: Table Of Contents
Contents Operation Guide Introduction & Safety Considerations ................3 To Activate Remote Start ..................4-5 Deactivating Remote Start ................... 5 Valet Mode ........................ 5-6 Programming Transmitters ..................6-7 Limited Lifetime Warranty ................Back Cover Installation Programming Features ................... 8-10 About the Programmable Features ............... 10-11 Installation Instructions Installation Considerations, Cautions and Warnings .......... -
Page 3: Operation Guide Introduction & Safety Considerations
Introduction prevents accidental starter grind should the key be turned while the remote starter is in operation. Additionally, the Orange wire also provides the vehicle immobilizing fea- Congratulations for choosing your Remote Starter and enjoy the luxury of starting your ture for the Anti-Carjacking operation. -
Page 4: To Activate Remote Start
diagrams. The correct wire will show 12 Volts only when the headlight switch is in To Activate Remote Start: the "Parking Light" and "Head Light" positions. This wire can usually be found at the headlight switch, and various other locations within the vehicle, such as the rear body •... -
Page 5: Deactivating Remote Start
existing keyless entry or alarm system to activate the remote start operation. If the When you leave your vehicle, simply set the climate controls for what you would Pink/Black wire receives a Negative pulse, the unit will start the vehicle's engine, like to have operating upon remote starting - the heater, defroster or air conditioning. -
Page 6: Programming Transmitters
Once the unit is in Valet Mode, an attempt to remote start will instead be ac- factory alarm system. Connect the Yellow/Green wire to the wire in the vehicle knowledged by the parking lights turning on, then flashing rapidly, then 3 slow which is connected to one of the doorlock key cylinders. - Page 7 1) Connect the Black/Yellow wire to the vehicle's tach wire, which is found in the 4) Within 15 seconds press the next transmitter’s button. engine compartment, although in many cases it may also be located inside the ve- The Status Light turns off and the parking lights flash once. hicle.
-
Page 8: Installation
20-Gauge Black/Yellow Wire: Engine Detect Input Installation Connection Required. The Black/Yellow wire is the engine detect wire. The unit uti- It is highly recommended that this system be professionally installed, as the sophistication lizes two different methods of monitoring the vehicle during the remote starting process. of the modern automobile and the complexity of this type of product installation is often Consider both methods before selecting one to use, and then connect the Black/Yellow beyond the abilities of most do-it-yourselfers. - Page 9 How to program features: 18-Gauge Black Wire: System Ground 1) Turn the ignition key “On”, then “Off”. Connection Required. Connect the Black wire to a very good, clean chassis ground. A recommended connection is to an existing machine-thread bolt, either in the 2) Within 7 seconds press the Valet Switch 5 times.
-
Page 10: About The Programmable Features
To Additional 22 Gauge Blue Wire: Exiting Programming Mode: Optional Starter Circuit 500mA ( - ) Ignition Output Simply allow the unit to time out of Features Programming Mode by not perform- Relay Connection If Needed. ing any programming actions for 15 seconds; or, turn the ignition “On” to immediately exit the programming mode. - Page 11 Jumper second (4 brake presses). Programming the Yellow/Green Wire operation: Locate and open the small access panel • Feature 3 is “Single or Double Pulse Activation”. The “Double Pulse” on the top of the control module case. Place the option allows the unit, in certain vehicles, to activate remote starting by Jumper as shown on the pins below the removable locking the vehicle doors two times with the original keyless entry transmitter.
-
Page 12: Installation Instructions
Installation Instructions the 3-pin Red port to energize the second Starter wire. Note: If a security system is present which utilizes a starter interrupt circuit, After reading this manual, start the installation by affixing the WARN- the Green wire must be connected to the Starter Motor side of the interrupt. ING DECAL to a visible area in the engine compartment! 12-Gauge Yellow Wire: Ignition Output... -
Page 13: Main Module
mined which control module wires will be used. Most installers will list these Receiver Module: wires, then "map out" the installation by locating and noting the target wires in The unit has a plug-in window mount Receiver Module. Optimum performance is the vehicle. -
Page 14: Wiring Diagram
Black/Yellow: WIRING DIAGRAM Receiver (Tach Wire) (Smart Start) Tach Smart Hood Pin Unit To Coil To Battery + Wire Switch Start Adjust Starter Adjust Yellow/Green: Orange: (-) Output When OEM Disarm Adjustment Activated Valet Blue: OPTIONAL Yellow/Red: Switch Relay For Yellow/Green: OEM Arm Anti-Grind...