Setting Up The Printer After Transporting It; Nozzle Check; Moving The Printer On The Stand - Epson Stylus Pro 10000 Product Information

EPSON Stylus Pro 10000
6. Have four people lift the printer off of the stand, using the
hand grips located at the four corners of the printer. Lift the
back of the printer first, tilt it slightly to the front, then slide
it back to remove it.
Warning:
The printer weighs approximately 291 lb (132 kg). Always have
four people lift it, using the hand grip areas illustrated above.
7. Keep the printer level while you move it.
Setting Up the Printer After
Transporting It
Setting up the printer after transporting it is almost identical
to setting it up for the first time. Whenever you set up the
printer, see the Unpacking and Assembly Guide, and note the
following points:
Don't forget to remove any protective material (such as tape
from the ink cartridge clamps).
If the automatic nozzle check is enabled (default), the
printer automatically runs a nozzle check and cleaning cycle
when you turn it on. You may also need to realign the print
head (see page 12) to ensure good print quality.

Moving the Printer on the Stand

When you want to move the printer a short distance, such as
within the same building or facility, you can roll the printer
on its casters. Follow these steps:
Caution:
Do not roll the printer on angled or uneven surfaces.
1. Make sure that the power cord, interface cable, roll paper
spindles, and all paper are removed, and the roll paper cover
and lower cover are closed.
14 - EPSON Stylus Pro 10000
2. Fully insert the upper and lower hammock guides, then roll
up the paper hammock.
3. Release the front casters and retract the stabilizer knobs.
4. Carefully roll the printer to its new location. Relock the
casters and extend the stabilizer knobs after moving.
The first time you start printing after moving the printer, you
may need to realign the print head (see page 12) to ensure
good print quality. If you see the message
on the display, turn the printer off and then on again.
ERROR
The printer automatically runs a nozzle check and cleaning
cycle whenever it is turned on.
5/01

NOZZLE CHECK