Setting Up The Printer After Transporting It; Related Documentation; Moving The Printer On The Stand - Epson Stylus Pro 9000 Series Manual

Setting Up the Printer After
Transporting It
Setting up the printer after transporting it is almost identical
to setting it up for the first time. Whenever you set up the
printer, see the Assembly and Setup Instructions, and note the
following points:
❏ Don't forget to open the side ink valve locks. The printer
can't print while they are closed.
❏ Don't forget to remove any protective material (such as tape
from the ink cartridge clamps).
❏ The first time you start printing after moving the printer,
the print head nozzles may be clogged. You may need to run
a cleaning cycle (see page 10) and realign the print head (see
page 10) to ensure good print quality.
❏ If you reinstall the cartridges you removed, make sure the
printer is turned off. Otherwise, the printer may not be able
to determine the correct level of remaining ink and the
lights may not flash to warn you when a cartridge is
Out
almost empty.
❏ If the ink lines were drained, EPSON recommends
installing new cartridges. Because of the ink charging
process, you will not be able to save ink by reinstalling used
cartridges.

Moving the Printer on the Stand

When you want to transport the printer a short distance, such
as within the same building or facility, you can roll the printer
on its casters. Follow these steps:
Caution:
Do not roll the printer on angled or uneven surfaces.
1. Make sure that the power cord, interface cable, roll paper
spindles and sheet media are removed, and the roll paper
cover and lower cover are closed.
2. Release the front casters and retract the stabilizer knobs.
3. Carefully roll the printer to its new location. Relock the
casters and extend the stabilizer knobs after moving.

Related Documentation

CPD 10847
CPD 10848
4009903
4012670
Ink
8/00
EPSON Stylus Pro 9000 series
EPSON Stylus Pro 9000 series Printer
Guide
EPSON Stylus Pro 9000 series Quick
Reference Guide
EPSON Stylus Pro 9000 Assembly and
Setup Instructions
EPSON Stylus Pro 9500 Assembly and
Setup Instructions
EPSON Stylus Pro 9000 series - 13