Table of Contents
Advertisement
SUPERSERVER 6028TR-DTR/D72R USER'S MANUAL
5-8
Connector Definitions
Main Power
Main power to the serverboard is supplied through the system backplane (BPN-
SAS-217HQ), which receives power directly from the power supply. One hard drive
midplane in each node (BPN-ADP-S2208L-H6iR) plugs into the backplane and the
JF1 connector on the serverboard
Front Panel Accessible Add-on Card Connector
The JF1 add-on card header provides front access to the power supply and the
Front Panel Control connections for the X10DRT series serverboard. Insert an Add-
On card into this connector to use the functions indicated above. This connector is
designed specifically for a Supermicro-proprietary add-on card. Refer to the layout
below for the location of JF1.
Ethernet LAN Ports
Two Gigabit Ethernet ports (LAN1/2) are located on the I/O backplane on the
X10DRT-H. In addition, a dedicated IPMI LAN port is located above USB 0/1 ports
on the backplane to provide KVM support for IPMI 2.0. All ports accept RJ45 type
cables.
Note: Refer to the LED indicator section for LAN LED information.
Standby Power Header
The Standby Power header is located at
JSTBY1 on the serverboard.
Universal Serial Bus
Two USB 3.0 ports (USB 0/1) are located
on the rear I/O panel. See the table on
the right for pin definitions.
Standby Power
Pin#
1
2
3
Pin Definitions
Pin #
Definition
1
+5V
3
D+
5
RX-
7
Ground
9
TX+
5-14
Header
Pin Definitions
Definition
+5V Standby
Ground
Wake-up
USB0/1
Pin # Definition
2
D-
4
Ground
6
RX+
8
TX-
Advertisement
Table of Contents
