Supero SUPERSERVER 6028TR-DTR User Manual page 66

SUPERSERVER 6028TR-DTR/D72R USER'S MANUAL
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that can reboot the system when a
software application hangs. Close pins
1-2 to reset the system if an application
hangs. Close pins 2-3 to generate
non-maskable interrupt signals for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is pins 1-2 to enable the
connection. See the table on the right for
jumper settings.
BMC Enable
Jumper JPB1 allows you to enable the
onboard BMC (Baseboard Management
Controller) to provide IPMI 2.0/KVM
support on the serverboard. Be sure to
remove the power cord before closing
pins 2-3 to disable the BMC. See the
table on the right for jumper settings.
JI C1 and JI C2
2 2
Jumpers JI C1 and JI
2
the connection of the the System
Management Bus (I
slots. The default setting is on pins 2-3
for normal operation. See the table on
the right for jumper settings.
C2 allows
2
C) to PCI-Express
2
5-18
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enabled
Pins 2-3 Normal
I C to PCI-Exp
2
Jumper Sett
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Normal
ings