Table of Contents
Advertisement
SUPERSERVER 2028TP-HTR/HTTR/HTFR USER'S MANUAL
5-8
Connector Definitions
Main Power
Main power to the serverboard is supplied through the system backplane (BPN-
SAS3-217HQ), which receives power directly from the power supply. One hard drive
backplane in each node (BPN-ADP-6SATA3P) plugs into system backplane and the
JF1 connector on the serverboard
Ethernet LAN Ports
Two Gigabit Ethernet ports (LAN1/2) are located on the I/O backplane on
theX10DRT-P and X10DRT-PIBF. The X10DRT-PT features two 10 Gb Ethernet
ports, also designated LAN1/2. In addition, an IPMI Dedicated LAN is located above
USB 0/1 ports on the backplane to provide KVM support for IPMI 2.0. All ports
accept RJ45 type cables.
Note: Refer to the LED Indicator Section for LAN LED information.
Universal Serial Bus (USB)
Two USB 3.0 ports (USB 0/1) are located
on the rear I/O panel. See the table on
the right for pin definitions.
USB0/1
Definitions
Pin# Definition
1
2
3
4
5
6
7
8
9
5-14
Pin
+5V
D-
D+
Ground
RX-
RX+
Ground
TX-
TX+
Advertisement
Table of Contents
