Table of Contents
Advertisement
96
97
Troubleshooting
5 .2
Kobold eb400 automatIc electrIc brush
fault
The Automatic Electric Brush is too
loud.
1
2
4
3
8
Threads have coiled around the roller
brush.
The slider for switching between
coarse materials and fine dust on
the underside of the Automatic
Electric Brush cannot be moved.
Possible causes and rectification
The roller brush
of the gear mechanism.
•
Check if the roller brush
mount it on the TORx
nism if necessary.
The small bearing ball
missing.
•
Make sure that the bearing ball
ed.
The green cap of the cup and ball bearing
properly installed.
•
Check if the green cap
then position the green cap correctly
5
The floor plate is not properly engaged
•
Make sure that both locks (left and right)
audibly with a click during installation
6
Maybe original Kobold accessories were not used,
7
which can lead to bearing or motor damage.
•
Use original Kobold roller brushes only.
An object might have got stuck in the area around the
9
roller brushes.
•
Remove the object.
•
Cut the threads as described in the chapter "Clean-
ing the roller brush" on page 86.
The Automatic Electric Brush is in hard floor mode.
•
Make sure that the Automatic Electric Brush was
properly switched off. Connect the Automatic
Electric Brush to the Cylinder Vacuum Cleaner and
switch it on and off again in the standby position
(joint locked).
The Automatic Electric Brush is now in carpet mode.
is not mounted on the TORx
is correctly inserted and
cam
of the gear mecha-
®
of the cup and ball bearing is
is properly insert-
is properly installed. If not
cam
®
is not
.
.
engage
.
Hide quick links:
Advertisement
Table of Contents
