Table of Contents
Advertisement
5 .4
Kobold sP600
fault
The SP600 switches itself off and
the LED waves are lit up red.
The Cylinder Vacuum Cleaner
switches itself off and the SP600
switches off simultaneously.
The LED waves are flashing red and
the inspection flap comes open.
When switching on the Cylinder
Vacuum Cleaner, the LED waves on
the SP600 light up red.
The suction channel of the SP600 is
blocked.
The joint connector of the SP600 is
blocked.
Possible causes and rectification
It is possible that the motor is overstrained.
•
Switch the Cylinder Vacuum Cleaner off.
•
Let the motor cool down.
•
Switch the Cylinder Vacuum Cleaner on.
Moisture has been sucked in.
•
Switch the Cylinder Vacuum Cleaner off.
•
Using a kitchen towel, dry the area of the suction
channel that is exposed by the inspection flap.
•
After the device has dried completely, switch on the
Cylinder Vacuum Cleaner and close the secondary
air flap of the SP600.
•
It is possible that this step will need to be repeated
several times.
The inspection flap on the SP600 has been opened be-
fore the vacuum cleaner was switched on.
•
Switch the Cylinder Vacuum Cleaner off.
•
Close the flap.
•
Then switch the Cylinder Vacuum Cleaner back on
again.
•
Switch the Cylinder Vacuum Cleaner off.
•
Open the inspection flap on the left hand side of the
device. This can be done by inserting a coin into the
groove
The magnetic latch on the inspection flap comes
open
. You can now clearly see inside the suction
channel.
•
Remove any objects that are blocking the suction
channel
(e.g. screwdriver, crochet needle).
•
Close the inspection flap again by pressing it. shut.
The magnetic latch on the inspection flap will click
into place and it is now firmly closed.
•
Also check whether the suction openings between
3
the sealing lips are clear. If necessary, shake out any
objects inside.
•
Remove the blockage with a suitable tool (e.g.
screw driver, crochet hook).
.
. To do this, use an appropriate object
Hide quick links:
Advertisement
Table of Contents
