Web Interface And Settings; Access & Ip Address - Vidicode V-Tap ISDN BRI Manual

Hide thumbs Also See for V-Tap ISDN BRI:

Table of Contents

3 Web interface and Settings

There are two ways to access the web interface of the V-Tap:

1) Connect a network cable to the LAN port on the unit. The other

side of the cable can be connected to a LAN or directly to a PC.

There is no need to use a cross-cable.

2) When a Wi-Fi module is available and enabled on the V-Tap:

Searching for Wi-Fi apparatus on your mobile phone or a laptop

should display the name "V-Tap_......". The last 6 digits of the

name are the last digits of the MAC address. The first 6 digits of

the MAC address are always 000349. The complete 12 digits are

used as the default Wi-Fi password.

3.1 Access & IP address

In the case of using Wi-Fi, you need to enter the Wi-Fi access password,

which is the 12 digits MAC address of the V-Tap, found on the bottom.

Then the IP address 192.168.55.66 must be entered in a browser.

In the case of using a cable, DHCP is enabled and the V-Tap can be

accessed with a browser by entering the address

XXXX

are the last 4 digits of the MAC address, found on the bottom:

Default cable address:

Default web Username: admin

Default web Password:

Default Wi-Fi Password: 00034901019E <

Default Wi-Fi IP address: 192.168.55.66

If no DHCP is available, it can be disabled temporary by pressing the

button for 1 second. The LED's will flash shortly and the V-Tap can be

accessed on the IP address 192.168.55.66

Do you have a question about the V-Tap ISDN BRI and is the answer not in the manual?

V-tap isdn pri