Table of Contents
Advertisement
3.3 Settings
The settings are divided into groups that are described in the following
paragraphs.
3.3.1
Name of this V-Tap
This field can be filled in with any name you like and is used for
remote recognition of the V-Tap unit. The name is shown in the web
interface and after connecting with ftp or telnet. The name is not
used in the Tunnel protocol. The maximum length is 30 characters.
The single and double quotation marks (' and ") cannot be used !
DHCP Server
Default, DHCP is enabled and the V-Tap can be accessed with a
browser by entering the address
XXXX
are the last 4 digits of the MAC address, found on the bottom.
When a DHCP server is available on the network, the IP address,
Subnet mask, Gateway address and DNS address are automatically
assigned. Without DHCP, they must all be entered manually.
With default settings, DHCP can be disabled temporary by pressing
the button for 1 second, see
The DHCP setting is not used for Wi-Fi connections.
IP Address
As part of the local network, the V-Tap needs an IP address. In case
DHCP is used, the DHCP server will assign the V-Tap an IP address. In
case DHCP is not used, a static IP address must be filled in.
The default address is 192.168.55.66 , see also
See the next page to setup for VLAN usage.
Subnet Mask
The subnet mask is used for so called 'subnetting', a way to logically
divide one network into more networks. The logical AND of the IP
address with the mask must be the same for the V-Tap and the
computer connecting to it. The default mask is 255.255.255.0.
In case DHCP is used, the mask is automatically obtained.
V-Tap ISDN BRI Manual EN v2.21 April 2021
General Network settings
Disable DHCP
http://vtapXXXX.local
temporary.
Access & IP
© 2017-2021 Vidicode
Address.
12
Advertisement
Table of Contents
