Table of Contents
Advertisement
OPERATOR MANUAL
Optional Accessories and Kits
Mounting Stand: An optional stand is available from Kodak. The processor stand provides a sturdy
work surface for the processor and occupies a minimum amount of space. By using the optional Kodak
M35, M43, Clinic 1 Mounting Stand, you are ensured that the processor will be at a convenient height
for feeding films. The Mounting Stand also provides the convenience of a slide-out shelf in the base
on which you may store replenishment supply tanks. Order CAT No. 808 1176.
Lighttight Feed Tray: An optional Lighttight Feed Tray Kit is available from Kodak. The Lighttight
Feed Tray allows you to turn on the darkroom lights immediately upon feeding the last sheet of film.
Order CAT No. 188 0335.
Transformer Kit: If your site does not meet the voltage specifications as outlined in the Site
Specifications, Publication Number 981087, a qualified service person can install a Transformer Kit to
ensure that your voltage will be within the correct specifications at all times. For Clinic 1 and M43A
sites whose voltage is not within the range of 104 to 127 V AC at all times, order CAT No. 167 4340.
For M43 sites whose voltage is not within the range of 207 to 253 V AC at all times, order
CAT No. 171 0292. Be sure when having a Transformer Kit installed, that it is installed according to
local codes.
Seismic Anchor Bracket Kit: If the processor is to be installed in California or in any area where the
threat of earthquakes or tremors exists, you can order the Seismic Anchor Bracket Kit. Use the
hardware supplied with the Mounting Stand to securely attach the processor to the Stand. The Seismic
Anchor Bracket Kit includes the hardware to enable a qualified service person to secure the Mounting
Stand to the floor. Order Part No. 261413. Be sure when having a Seismic Anchor Bracket Kit
installed, that it is installed according to local codes.
Vent Duct Adapter Kit: If you need venting capability, order a Vent Duct Adapter Kit that connects
to the processor. This kit can be used with the Auxiliary Ventilation Fan Kit (detailed below). For the
Vent Duct Adapter Kit, order CAT No. 143 4943.
Auxiliary Ventilation Fan Kit: If your site does not meet the specifications for room air changes as
outlined in the Site Specifications, Publication Number 981087, a qualified service person can install
the Kodak Auxiliary Ventilation Fan Kit with the Vent Duct Adapter Kit (detailed above). Order
Part No. 264503. Be sure when having a Ventilation Fan Kit installed, that it is installed according to
local codes. This kit is available for 115 V AC only and has a capacity of 122 cubic feet per minute.
Installation Kit: If your qualified service person is installing the Clinic 1 processor, the Installation
Kit provides all of the components necessary to install the processor. These parts are included when
purchasing the M43 and M43A processor models. Order CAT No. 863 2754.
Through-the-Wall Kit: If your qualified service person is installing the processor through the
darkroom wall, this kit includes all the components necessary to complete the installation. This kit
assumes the use of the Kodak M35, M43, Clinic 1 Mounting Stand (detailed above). For the Through-
the-Wall Kit, order CAT No. 871 3109.
4
September 1995 – 981089
Advertisement
Table of Contents
