To set Beacon Recovery:
1. Select the
Enable Beacon Recovery
2. Select
or
YES
3. Select
SAVE
The "
SAVED OK
Number of Retries
You can use the
the TRBMIM/TRBMIM-T will try to re-enable a disabled RI/RO port
from which a beaconing condition was detected.
The default value for the field is
follows:
0
1-100
999
101-998
To set the number of retries:
1. Select the
Number of Retries
2. Select
SAVE
The "
SAVED OK
Retry Interval
You can use the
between retries. Interval values must be specified as multiples of seven
(e.g., 14, 21, 28, . . ., 980, 987, 994). Values entered that are not multiples
of seven are automatically rounded to the next highest multiple of seven.
The default interval is
follows:
0
1-999
.
NO
, and then press the Enter key.
" message appears.
Number of Retries
Disable RI/RO port retries
Retry RI/RO ports n times (n = 1-100)
Infinite retries
Not accepted
, and then press the Enter key.
" message appears.
Retry Interval
seconds. Selection value ranges are described as
21
Disable ring port retries
Delay in seconds between retries
field.
field to set the number of times
. Selection value ranges are described as
4
field and type in an allowed value.
field to specify the interval in seconds
DEVICE SETUP MENU
4-7
Need help?
Do you have a question about the TRBMIM and is the answer not in the manual?