Table of Contents
Advertisement
Table 4-2 Normal Mode Error Indicator States
Activity
NE2: Hardware failure
NE5: Booted wrong image
Key:
= On continuously
= Flashing regularly (about 1Hz)
Activity NE2: Hardware Failure
The ROM diagnostics detected a Micro-CS hardware problem requiring
service. Call technical support.
Activity NE5: Booted Wrong Image
The Micro-CS has just loaded an inappropriate image. Pressing the
SETUP switch for approximately 3 seconds to generate a reset clears this
error. The Micro-CS loads inappropriate images if one of the following
operator errors occur:
•
Configuring the Micro-CS with an incorrect file name or renaming or
copying the image file to the wrong name.
•
Supplying the wrong name to any of the boot commands (na boot,
dumpboot, or the superuser CLI boot).
If you are uncertain as to why the Micro-CS booted the wrong image,
enter Set Up mode and issue an image -d command. This command
shows which host file the Micro-CS is trying to load.
SETUP Mode
Pressing the SETUP switch within 3 seconds of either a reset or cycling
on power puts the Micro-CS into Set Up mode. The SETUP indicator is
on after pressing the SETUP switch.
Micro-CS Installation Guide
Power-Up and Boot Procedures
STATUS
green
= Off
= Flashing irregularly
ATTN
NET
amber
green
4-3
Advertisement
Table of Contents
