Table of Contents
Advertisement
Chapter 1: Introduction
1.5.10 Console Port
The Micro-CS uses port 1 as a console port during SETUP. To access the
console port, press the Setup switch within 3 seconds of powering-up.
The console port provides access to the ROM Monitor commands when
the Micro-CS is in set up mode. After returning to normal mode, Port 1
functions as a serial port. Refer to Appendix B for console pinout
information.
1.5.11 Network Port
The Micro-CS can be connected to an Ethernet LAN either one of two
ways: through an RJ-45 connector to the MicroMMAC internal AUI, or
through an RJ-45 connector on the front panel between the network port
and a port on the MicroMMAC. The internal AUI is provided by the
Cabletron EPIM-3PS, provided with the Micro-CS. The Micro-CS
automatically sets up the connection, either internally to the
MicroMMAC, or externally to a 10BASE-T port. Refer to Appendix B for
port pinout information.
1.5.12 Modem Port
If your Micro-CS is equipped with the optional modem card, the punch
out on the faceplate should have been removed to expose the modem port.
This port supports a V.34 modem with an RJ-11 connector allowing
modem network access.
If your Micro-CS does not have the optional modem, then connecting to
the port is futile. The modem card can be purchased by contacting
Cabletron Customer Support at (603) 332-9400 and ordering part number
CSM-V.34-UGK.
1-8
Micro-CS Installation Guide
Advertisement
Table of Contents
