Table of Contents
Advertisement
Chapter 2: Micro-CS Installation
Next, the Micro-CS runs diagnostic tests causing the NET indicator to
flash. If the diagnostics complete successfully, the STATUS and
ATTN indicators light, and the ROM Monitor prompt (
appears on the terminal. The tests complete in approximately one
minute. If the prompt appears, go to Step 4.
If the STAT and ATTN indicators do not light within one minute or if
the indicators flash, a hardware failure has occurred. Contact
Cabletron Technical Support.
4.
Verify the Micro-CS hardware configuration.
At the monitor prompt on the console, type config and press the
Return key. The following is a typical configuration display:
monitor:: config
ROM Software Rev: 0901
Board ID: 56
CPU Type: 486SXLC2
Memory Size: 4 Meg
Flash Size: 2 Meg
EEPROM Size: 32736
Installed Alternate Interface: ThinNet
ASYNC Config
Number of Ports: 16
Max Port Speed: 115.2 Kbps
2-4
REVISION/CONFIGURATION INFORMATION
Board Type: Remote Annex 2000
Ethernet Address: 00-80-2D-00-C6-1E
Flash ID: 8989
monitor::
Micro-CS Installation Guide
)
Advertisement
Table of Contents
Need help?
Do you have a question about the MicroMMAC 22ES and is the answer not in the manual?