Table of Contents
Advertisement
MICRO-CS UPGRADE INSTALLATION
D.1
GENERAL
In most cases, the Micro-CS will come factory installed and
preconfigured. However, because it is also available as an upgrade, this
section details the installation of a Micro-CS into a MicroMMAC. See the
appropriate appendices for the installation of additional memory and/or
Flash upgrades. After completing the physical installation, please return
to Chapter 2 for setup information.
D.2
LOCATING THE CONFIGURATION JUMPERS
The Micro-CS has 5 jumpers. Figure E-1 shows the locations of the
jumpers. Please note that the pins on the Micro-CS are to be read from left
to right.
J18
J10
J2
SIMM CARDS
Micro-CS Installation Guide
APPENDIX D
J16
1 2 3 1 2 3
Figure D-1 Jumper Locations
J25
1
2
3
D-1
Advertisement
Table of Contents
