Table of Contents
Advertisement
3.2.3
config
The config command displays the Micro-CS's total number of ports, total
amount of memory, the ID number, the serial number, the major and
minor hardware revision numbers, and the ROM software revision
number. The config command display contains information describing
whether or not Flash ROM is installed. The command syntax is:
config
The config command display looks like this:
monitor:: config
ROM Software Rev: 0901
Board ID: 56
CPU Type: 486SXLC2
Memory Size: 4 Meg
Flash Size: 2 Meg
EEPROM Size: 32736
Installed Alternate Interface: ThinNet
ASYNC Config
Number of Ports: 16
Max Port Speed: 115.2 Kbps
3.2.4
console-baud
The console-baud command changes the console port's baud rate. Thus,
the console port can interface with any modem to which it is connected.
When the baud rate is entered as auto, the Micro-CS detects the baud rate
of the incoming line and adjusts its baud rate accordingly. This command
provides support for remote troubleshooting. The command syntax is:
console-baud
Micro-CS Installation Guide
REVISION/CONFIGURATION INFORMATION
Board Type:
Ethernet Address: 00-80-2D-00-C6-1E
Flash ID: 8989
Micro-CS
Commands
3-11
Advertisement
Table of Contents
