Table of Contents
Advertisement
2.1
GENERAL
The Micro-CS comes factory installed in the MicroMMAC as a
MicroCS-T-22ES, or MicroCS-LT-22ES, or can be ordered seperately as
an upgrade kit, part number MICRO-CST-UGK or MICRO-CSLT-UGK.
If you have the upgrade kit, please refer to Appendix E for installation
instructions.
Installation procedures for the MicroCS follow those of the Cabletron
Systems MicroMMAC series. For installation and Local Management
instructions related to the Ethernet networking functionality of the
MicroCS, please refer to the MicroMMAC documentation.
This chapter explains the connection of serial devices, attaching to the
console port, power up and testing, and software installation of your new
Micro-CS. Please read through all the material before powering up to gain
an understanding of how to set up the system.
2.2
CONSOLE PORT TERMINAL
In order to access the ROM Monitor and boot the Micro-CS for the first
time, the Micro-CS must be connected to a terminal. Connect the console
terminal to port 1. Set the terminal to 9600 baud, eight data bits, no parity,
one stop bit, and XON/XOFF flow control. The ROM Monitor assumes
that this terminal is CRT-based and displays the backspace (BS) character
accordingly.
Appendix A describes the console port's signal/pin allocations.
Micro-CS Installation Guide
CHAPTER 2
MICRO-CS INSTALLATION
2-1
Advertisement
Table of Contents
