Table of Contents
Advertisement
Appendix D: Micro-CS Upgrade Installation
D.5
INSTALLING THE MICRO-CS UPGRADE
Ensure that the power cord is removed from the unit before
removing the cover. Do not remove any screws other than
those necessary for this installation. Failure to follow these
warnings may result in the presence of an electrical hazard.
1.
Remove the cover from the MicroMMAC.
Depending on the configuration of your MicroMMAC, you may have to
remove certain components at this time.
2.
Remove the upper port cutout blank, or the 12 port daughter card from
the MicroMMAC.
D-4
NVRAM Switch
Figure D-2 : Cover Removal
Chassis Cover
Chassis
BRIM Slot
Cover Screw (7)
Micro-CS Installation Guide
Advertisement
Table of Contents
