Cabletron Systems MicroMMAC 22ES Installation Manual page 55

Prompt
Allow SLIP on this port
Enter local endpoint
address
Enter remote
endpoint address
Enter remote
load/dump host
address
Should this interface
be used for memory
dumps
Enter the baud rate
Enter the number of
stop bits
Enter the parity
Micro-CS Installation Guide
Table 3-2 . The slip Command Prompts
Description
Modifies the port's mode. A y response changes
the port to a SLIP interface. An n response changes
the port's mode to CLI. The port is not available as
a SLIP interface and the SLIP parameters are
ignored. The default is n.
Specifies the Micro-CS IP address for this SLIP
interface. The Micro-CS boots over the SLIP
interface only if this address is set.
Specifies the IP address of the remote end of the
SLIP interface.
Specifies the IP address of the remote host to
which load and dump requests are sent. This
address is required only if the remote host is a
gateway and not the load host. By default, this is the
same as the remote end-point address.
Enables the Micro-CS to use a SLIP interface for
memory dumps. The default is y.
Specifies the baud rate of the serial interface. The
default is 9600.
Pressing the
(one). Generally, SLIP implementations require
the default.
Pressing the
(none). Generally, SLIP implementations require
the default.
RETURN
key accepts the default
RETURN
key accepts the default
Commands
3-23