Q Vlan Current Table Information - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

802.1Q VLAN Current Table Information

This screen shows the current port members of each VLAN and whether
or not the port supports VLAN tagging. Ports assigned to a large VLAN
group that crosses several switches should use VLAN tagging. However,
if you just want to create a small port-based VLAN for one or two switches,
you can assign ports to the same untagged VLAN (page 48). The current
configuration is shown in the following figure.
VID
----------------------------------------------------------------
1
Unit Current Egress Ports
1 111111111111 111111111111 ----
Sorted by VID : 1
[Show]
Figure 2-39. 802.1Q VLAN Current Table Information
Parameter
Deleted VLAN
Entry Counts
VID
Creation Time
Status
Unit
Current Egress
Ports
Current Untagged
Ports
[Show]
[More]
52 VH-2402S2 User Interface
Vertical Horizon Stack Local Management
802.1Q VLAN Current Table Information
Deleted VLAN Entry Counts : 0
Creation Time
0 (0 day 0 hr 0 min 0 sec)
Port 1
[More]
<OK>
Use <TAB> or arrow keys to move. <Enter> to select
Description
The number of times a VLAN entry has been deleted from this table.
The ID for the VLAN currently displayed.
The value of sysUpTime (System Up Time) when this VLAN was
created.
Shows how this VLAN was added to the switch:
Dynamic GVRP: Automatically learned via GVRP.
Permanent:
Stack unit.
Shows the ports which have been added to the displayed VLAN
group, where "1" indicates that a port is a member and "0" that it is not.
If a port has been added to the displayed VLAN (see Current Egress
Ports), its entry in this field will be "1" if the port is untagged or "0" if
tagged.
Displays the members for the VLAN indicated by the "Sorted by VID"
field.
Displays any subsequent VLANs if configured.
Current Untagged Ports
111111111111 111111111111 ----
Port 13 Port 25
<PREV UNIT>
Added as a static entry.
Status
Permanent
<NEXT UNIT>
VH-2402S2