Configuring The Switch - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Configuring the Switch

The Device Control menu is used to control a broad range of functions,
including port configuration, Spanning Tree support for redundant
switches, port mirroring, multicast filtering, and Virtual LANs. Each of the
setup screens provided by these configuration menus is described in the
following sections.
Port Configuration ...
Port Information ...
Port Security Configuration ...
Port Trunking Configuration ...
Port GARP Configuration ...
Port GMRP Configuration ...
Extended Bridge Configuration ... 802.1Q VLAN Static Table Configuration ...
Spanning Tree Configuration ...
Spanning Tree Information ...
Mirror Port Configuration ...
BStorm Control Configuration ...
Use <TAB> or arrow keys to move. <Enter> to select.
Selection
Port Configuration
Port Information
Port Security
Configuration
Port Trunking
Configuration
Port GARP
Configuration*
Port GMRP
Configuration*
Extended Bridge
Configuration
Spanning Tree
Configuration
Spanning Tree
Information
Mirror Port
Configuration
BStorm Control
Configuration
9033820-03
Vertical Horizon Stack Local Management
Device Control Menu
Global VLAN Configuration ...
Port Assignment VLAN Configuration ...
Egress Ports VLAN Config ...
VLAN Forbidden Ports Config ...
802.1Q VLAN Base Information ...
802.1Q VLAN Current Table Information ...
802.1P Configuration ...
IGMP Configuration ...
IGMP Member Port Configuration ...
Multicast Router Port Configuration ...
Figure 2-20. Device Control Menu
Description
Sets communication parameters for ports.
Displays current port settings and port status.
Allows you to enable and configure port security for the switch.
Specifies ports to group into aggregate trunks.
Configures generic attribute settings used in the spanning tree
protocol, VLAN registration, multicast filtering.
Configures GMRP multicast filtering.
Displays/configures extended bridge capabilities provided by this
switch, including support for traffic classes, and VLAN extensions.
Configures the switch, its ports and modules to participate in a
local Spanning Tree.
Displays the current Spanning Tree configuration for the switch,
its ports and modules.
Sets the source and target ports for mirroring.
Allows you to enable broadcast storm control and set the packet-
per-second threshold.
<OK>
VH-2402S2 User Interface 29