Configuring Bridge Mib Extensions - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Configuring Bridge MIB Extensions

The Bridge MIB includes extensions for managed devices that support
Traffic Classes, Multicast Filtering and Virtual LANs. To configure these
extensions, use the Extended Bridge Configuration screen as shown
below:
Bridge Capability : (Read Only)
Bridge Settings :
Use <TAB> or arrow keys to move, <Space> to scroll options.
Parameter
Bridge Capability
Extended Multicast
Filtering Services
Traffic Classes
Static Entry
Individual Port
Configurable
PVID Tagging
Local VLAN
Capable
36 VH-2402S2 User Interface
Vertical Horizon Stack Local Management
Extended Bridge Configuration
Extended Multicast Filtering Services : NO
Traffic Classes
Static Entry Individual Port
Configurable PVID Tagging
Local VLAN Capable
Traffic Classes
VLAN Learning
GMRP
GVRP
<APPLY>
Figure 2-25. Extended Bridge Configuration
Description
Indicates that this switch does not support the filtering of
individual multicast addresses based on GMRP (GARP Multicast
Registration Protocol). Note that this function is not available for
the current firmware release.
This switch provides mapping of user priorities to multiple traffic
classes. (Refer to 802.1P Configuration.)
This switch enables static filtering for unicast and multicast
addresses. (Refer to Network Monitor Menu / Static Unicast
Address Table Configuration and Static Multicast Address Table
Configuration.)
This switch allows you to override the default PVID setting (Port
VLAN ID used in frame tags) and its egress status (VLAN-Tagged
or Untagged) on each port. (Refer to Port Assignment VLAN
Configuration.)
This switch does not support multiple local bridges (that is,
multiple Spanning Trees).
: TRUE
: SVL
: DISABLED
: DISABLED
<OK>
: YES
: YES
: YES
: NO
<CANCEL>
VH-2402S2