Enterasys Vertical Horizon VH-2402S2 Configuration Manual page 43

Enterasys vertical horizon vh-2402s2: user guide
Hide thumbs Also See for Vertical Horizon VH-2402S2:
Table of Contents

Advertisement

You can use the Port Trunking Configuration screen set up port trunks as
shown below:
Trunk ID
---------
--------
--
--------
--
--------
--
--------
Trunk ID : 1
[Show]
[Enable]
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Trunk ID
Unit
Port
[Show]
[More]
[Enable] [Disable]
The RJ-45 ports used for each trunk must all be on the same internal
switch chip. The port groups permitted include:
Group 1
1,2,3,4,
13,14,15,16
Only two 100Mbps fiber ports can be configured as a trunk and these
must be on the same module. 1000Base-SX/LX ports can be trunked
together with any other like uplink ports in the stack.
9033820-03
Vertical Horizon Stack Local Management
Port Trunking Configuration
Status
1
-----------
Unit : -
Port : --
Unit : -
Port : --
Unit : -
Port : --
[More]
[Disable]
Figure 2-24. Port Trunking Configuration
Description
Configure up to five trunks per standalone switch, or up to 12 for
an entire stack.
Specifies a switch unit in the stack (1~7).
Select from 2~4 ports per trunk.
Displays trunk settings, where the first trunk listed is specified by
"Sorted by Trunk ID."
Scrolls through the list of configured trunks.
Enables/disables the selected trunk.
Member List
2
-----------
-----------
Unit : -
Port : --
Unit : -
Port : --
Unit : -
Port : --
Trunk ID : 1
[Add]
[Delete]
<OK>
Group 2
5,6,7,8,
17,18,19,20
3
4
-----------
Unit : -
Unit : -
Port : --
Port : --
Unit : -
Unit : -
Port : --
Port : --
Unit : -
Unit : -
Port : --
Port : --
Member Unit : 1
Member Port : 1
Group 3
9,10,11,12,
21,22,23,24
VH-2402S2 User Interface 35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vertical horizon vh-2402sm2

Table of Contents