Enterasys Vertical Horizon VH-2402S2 Configuration Manual page 18

Selection
Management
Configuration
Device Control Menu
Port Configuration
Port Information
Port Security
Configuration
Port Trunking
Configuration
Extented Bridge
Configuration
Spanning Tree
Configuration
Spanning Tree
Information
Mirror Port
Configuration
BStorm Control
Configuration
Global VLAN
Configuration
Port Assignment
VLAN Configuration
Egress Ports VLAN
Configuration
VLAN Forbidden Ports
Configuration
802.1Q VLAN
Base Information
802.1Q VLAN Current
Table Information
802.1Q VLAN Static
Table Configuration
802.1P Configuration
IGMP Configuration
IGMP Member Port
Configuration
Multicast Router Port
Configuration
10 VH-2402S2 User Interface
Description
Specifies if management access to the switch is available
from all VLANs or restricted to one VLAN.
Enables any port, enables/disables flow control, and sets
communication mode to auto-negotiation, full duplex or half
duplex.
Displays operational status, including link state, flow control
method, and duplex mode.
Allows you to enable and configure port security for the
switch.
Specifies ports to group into aggregate trunks.
Displays/configures extended bridge capabilities provided by
this switch, including support for traffic classes, GMRP
multicast filtering, and VLAN extensions.
Enables Spanning Tree Algorithm; also sets parameters for
hello time, maximum message age, switch priority, and
forward delay; as well as port priority and path cost.
Displays full listing of parameters for the Spanning Tree
Algorithm.
Sets the source and target ports for mirroring.
Allows you to enable broadcast storm control and set the
packet-per-second threshold.
Displays basic VLAN information, such as VLAN version
number and maximum VLANs supported, and allows you to
enable/disable each VLAN.
Displays/configures port-specific VLAN settings, including
PVID, ingress filtering, and 802.1Q trunks.
Configures VLAN groups via static assignments to individual
ports or a range of ports, including setting ports as members
and configuring them as untagged.
Restricts individual ports or a range of ports from being
dynamically added to a VLAN by the GVRP protocol.
Displays basic VLAN information, such as VLAN version
number and maximum VLANs supported.
Displays VLAN groups and port members.
Configures VLAN groups via static assignments, including
setting port members, or restricting ports from being
dynamically added to a VLAN by the GVRP protocol.
Configures default port priorities and queue assignments.
Configures IGMP multicast filtering.
Assigns ports that are attached to hosts who want to receive
a specific multicast service.
Displays the ports on the switch attached to a neighboring
multicast router/switch for each VLAN ID.
VH-2402S2