Configuring Vlans; Configuring Class Of Service - Enterasys Vertical Horizon VH-2402S2 Configuration Manual

Configuring VLANs

A virtual LAN (VLAN) is a group of devices on one or more LANs that are
configured such that they can communicate as if they were attached to
the same wire. Because VLANs are based on logical instead of physical
connections, they are extremely flexible.
The most fundamental benefit of VLAN technology is the ability to create
workgroups based on function rather than on physical location or media.
For further information, see Appendix B, "Virtual LANs (VLANs)" on page
97.
To configure VLANs, do the following:
1. Select the Device Control Menu from the Main Menu.
2. Select 802.1Q VLAN Static Table Configuration Menu.
3. In the VID and VLAN Name fields, enter an ID number (1-2048) and
a symbolic alphanumeric name (up to 8 characters) to indentify the
VLAN.
4. Set the Status field to Active and then select Apply to save the
settings.
5. From the Device Control Menu, select Port Assignment VLAN
Configuration.
6. For each VLAN port member, set the PVID to the VLAN ID.
7. Select Apply to save the settings and return the 802.1Q VLAN Static
Table Configuration screen.
8. Under Forbidden Egress Ports for each stack unit, enter a "1" to
prevent a port from being automatically added to this VLAN via
GVRP.
Note that you can enable or disable GVRP for the stack from the
Extended Bridge Configuration screen on the Device Control Menu.
9. To configure other VLANs, select New and press [Enter].

Configuring Class of Service

You can configure Class of Service parameters using the 802.1P Port
Priority Configuration screen. This screen permits you to configure two
priority levels for traffic being forwarded through the switch. During
periods of congestion, Class of Service settings ensure that traffic which
has been assigned high priority is forwarded through the switch ahead of
normal priority traffic. For further information, see Appendix C, "Class of
Service" on page 101."
To configure Class of Service, do the following:
1. Select Device Control Menu from the Main Menu.
2. Select 802.1P Configuration, then 802.1P Port Priority Configuration.
9033820-03
Configuring & Monitoring the Switch 79