Installation; Mini-Gbic With Mt-Rj Connector - Enterasys SecureStack C2 C2G124-24 Hardware Installation Manual

Installing Optional Mini-GBICs

Installation

To install a Mini‐GBIC that has an MT‐RJ connector, refer to Figure
with an LC connector, refer to Figure
1. Hold the Mini‐GBIC with the top side positioned as shown, and the 7‐pin edge
connector facing the port slot.
2. Align the Mini‐GBIC with the port slot.
3. Push the Mini‐GBIC into the port slot until the Mini‐GBIC "clicks" and locks into
place.
Figure 3-1
1 Mini-GBIC (MGBIC-MT01)
2 Mini-GBIC
3 7-pin edge connector (insertion side)
3-4 Hardware Installation
Note: If the Mini-GBIC is one with an RJ45 connector (not shown), the installation
procedure is the same as described below. However, the Mini-GBIC has a wire handle to
release it.

Mini-GBIC with MT-RJ Connector

Á
Ä
Å
,
top side
3‐2, and proceed as follows:
Ã
Â
À
4 Port slot
5 Protective dust cover
6 Release tab
3‐1, or for a Mini‐GBIC