C2G124-24 And C2G124-48 - Enterasys SecureStack C2 C2G124-24 Hardware Installation Manual

Overview

C2G124-24 and C2G124-48

The C2G124‐24 (Figure 1‐1) and C2G124‐48 (Figure
port connections, which include:
• RJ45 ports (10/100/1000 Mbps, 1000BASE‐T copper ports), 24 on the C2G124‐24 and 48
on the C2G124‐48
• SFP slots that provide you with the option of installing Small Form Pluggable (SFP)
Mini‐GBICs for 1000BASE‐T compliant copper connections or 1000BASE‐SX/LX
fiber‐optic connections
• Rear panel connectors for high‐speed connections in a stack configuration
• Rear panel Redundant Power Supply connector for a redundant power supply
connection. The switch connects to a C2RPS‐SYS using a C2RPS‐PSM Cable.
The 10/100/1000 Mbps fixed front panel ports can operate in either half‐duplex or full‐
duplex mode, as determined by Auto‐Negotiation.
1-2 Introduction
Caution: The C2G124-24 and C2G124-48 are not PoE-compliant devices. Do not
connect a SecureStack C2 PoE Redundant Power System (C2RPS-POE) to the power
connector. Otherwise, damage to the device may result.
Precaución: Los dispositivos C2G124-24 y C2G124-48 no cumplen con el estándar PoE
(power over ethernet). No conecte una fuente de poder redundante (RPS) SecureStack
C2 PoE (C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede
dañarse.
Note: The Mini-GBIC ports cannot be active simultaneously with their corresponding
10/100/1000BASE-T ports. For example, if SFP port 24 establishes a link first on the
C2G124-24, the 10/100/1000BASE-T built-in RJ45 port 24 is not available and vice-versa.
1‐2) have several types of front panel