Completing The Installation; Initial Logon To Switch Management - Enterasys SecureStack C2 C2G124-24 Hardware Installation Manual

Completing the Installation

b. If there are separate fiber‐optic connections on the other device, check the
c.
d.
5. Repeat steps 1 through 4, above, until all connections have been made.

Completing the Installation

After installing the switch and making the connections to the network, access the switch
management, as described below.

Initial Logon to Switch Management

To initially access switch management from your local PC, terminal, or modem
connection, proceed as follows at the displayed startup screen:
1. Enter rw (Read‐Write) for Username.
2. At the Password prompt, press ENTER (RETURN).
3. For details on how to configure the switch using the command line interface, refer to
the SecureStack C2 Configuration Guide. The CLI commands enable you to set a new
password and perform more involved management configurations on the switch. One
of many capabilities is to reconfigure the stack, reassigning the Manager function to
another switch and configuring the order of Member switches that will take over the
stack management functions in case the operating Manager is powered down,
malfunctions, or is removed from the stack.
4. After the initial configuration, you can also use WebView (Enterasys Networks'
embedded web server) for configuration and management tasks.
All the guides associated with the switch are available online at:
http://www.enterasys.com/support/manuals
Once you are confident that the installation is successful, route and secure your cables. If
you require assistance, contact Enterasys Networks using one of the methods described in
"Getting Help" on page 1‐7.
3-30 Hardware Installation
crossover of the cables. Swap the cable connections if necessary.
Check that the fiber‐optic connection meets the dB loss and cable specifications
outlined in the Cabling Guide for multimode mode cabling. To obtain this
document, refer to "Related Documents" on page xvi.
If a link has not been established, refer to Chapter
details. If a problem persists, refer to refer to "Getting Help" on page 1‐7 for
details on contacting Enterasys Networks for support.
4 for LED troubleshooting