Mini-Gbic Installation - Enterasys Matrix E1 1G694-13 Installation Manual

Installing an Optional Mini-GBIC
Figure 3-3 Mini-GBIC Installation
Ä
Å
➀
Mini-GBIC
➁
,
Mini-GBIC top side
➂
7-Pin edge connector (insertion side)
Removing a Mini-GBIC
Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab located under
the front bottom end of the Mini-GBIC
The Mini-GBIC and switch are sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to do so can result in damage to the
Mini-GBIC and switch. Always leave the Mini-GBIC in the antistatic bag or an equivalent antistatic
container when not installed.
To remove a Mini-GBIC from the switch
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC.
2. Remove the network cable connected to the Mini-GBIC.
3-6 Hardware Installation
Á
Ã
À
refer to
,
➃
Switch port slot
➄
,
Mini-GBIC protective dust cover
➅
Locking tab
.
This can damage the Mini-GBIC.
Figure 3-3 and proceed as follows: