Connecting to COM Port for Local Management
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
Figure 3-10 Connecting to a VT Series Terminal
1 UTP straight-through cable with RJ45 connectors
2 RJ45 COM port
Connecting to a Modem
To connect a modem to an Enterasys Networks DFE‐Platinum module COM port
(Figure
male adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port of the DFE module.
2.
Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 male adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
4.
Turn on the modem.
3-18 Installation
Ã
3‐11), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
Â
À
Á
3 RJ45-to-DB25 female adapter
4 VT series terminal